Click OK, and hit Enter, and you should then see the iPrism console menu below. Name your connection (any name), specify the correct PC COM port, and set your baud rate to 9600, taking the defaults for the remaining COM port settings.Ĭlicking " Restore Defaults" will give you the settings you need automatically. Start > Programs > Accessories > Communications > HyperTerminalįrom Run command type 'HYPERTRM' and EnterĪ banner will display for a few seconds before the application opens. If you do not initially receive, or later misplace this cable, please contact EdgeWave for another cable. You cannot use a standard serial cable for the diagnostic connection. Note: Even though the console cable has DB9 connectors at each end, it is not a standard serial cable (different pin configuration). The console port is in back on the iPrism and is blue. Use the Console Cable shipped with your appliance to connect the PC & iPrism. To access the iPrism menu system, you must do the following:Ĭable the grey Null-Modem cable to PC/Laptop and M-series iPrism:
Then, repeat the process above and re-check HyperTerminal.Starting Console for Advanced Troubleshooting If you want to reinstall HyperTerminal, uncheck HyperTerminal and click OK. Check or uncheck the HyperTerminal option, to install or uninstall the program.In the Add/Remove Programs window, click the Windows Setup tab.In the Control Panel, double-click Add/Remove Programs.To install, uninstall, or reinstall HyperTerminal in Windows XP and earlier, follow the steps below. How to install, uninstall, or reinstall HyperTerminal If you don't see a Communications folder, look for the Accessories group. In the Program Manager window, open the Communications folder.
If you cannot locate HyperTerminal, it may not be installed. If you do not see Hyper Terminal, click the Communications folder and then click HyperTerminal. In the Accessories folder, click or double-click HyperTerminal.If you do not see HyperTerminal, it may not be installed. In the Communications folder, select HyperTerminal.Click Start > All Programs > Accessories > Communications.If HyperTerminal doesn't run in step 5 above, you may need to run the file in Windows compatibility mode for it to work, see: How to change the Windows compatibility mode.
0 kommentar(er)
